- This topic has 0 replies, 1 voice, and was last updated 11 years, 7 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
I am trying to measure 3 phase power factor using 3 phase calibrator in 3 phase 3 wire mode. When I set unity or any power factor in all phases, meter is not showing the same power factor or nearby but lot of difference observed. Can any one can give the relation between input & output or the reason why i am getting the difference.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.