Electrical Equipment
  • Home
  • Categories
    • Electrical distribution
    • Electrical Safety
    • Electrical software
    • Energy Efficiency – building
    • Energy Efficiency – kvar
    • Energy Efficiency – lighting
    • Energy Efficiency – motors
    • Energy Efficiency – news
    • Energy Efficiency – solar
    • Engineering Web tips
    • IEC standard
    • Panel Building
    • Power quality
    • Others
  • Resources
    • Electrical Calculation Tools
    • Electrical Engineering Forum
    • LED lighting resources area
    • Load Shedding Guide
    • Newsletters, archives
  • About us
    • How to help Electrical Engineering Community
    • Make a Comment, write a Post
    • Special thanks
Electrical Equipment
  • Home
  • Categories
    • Electrical distribution
    • Electrical Safety
    • Electrical software
    • Energy Efficiency – building
    • Energy Efficiency – kvar
    • Energy Efficiency – lighting
    • Energy Efficiency – motors
    • Energy Efficiency – news
    • Energy Efficiency – solar
    • Engineering Web tips
    • IEC standard
    • Panel Building
    • Power quality
    • Others
  • Resources
    • Electrical Calculation Tools
    • Electrical Engineering Forum
    • LED lighting resources area
    • Load Shedding Guide
    • Newsletters, archives
  • About us
    • How to help Electrical Engineering Community
    • Make a Comment, write a Post
    • Special thanks

Re: load calculation

Home › Electrical Engineering Forum › General Discussion › load calculation › Re: load calculation

2011/04/19 at 3:43 pm #11976
erickench
Participant

18.4 amps can't be correct. You must always assume that the AC and the heater are not going to operate at the same time. You must take the higher of these two loads in your calculations.

Copyright © 2023. Electrical Equipment.