how to minimise voltage drop problem in PLC wiring?

Home › Electrical Engineering Forum › General Discussion › how to minimise voltage drop problem in PLC wiring?

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2011/07/11 at 4:42 pm #10543
    admin
    Keymaster

    i want the ans for this question

    2011/07/11 at 5:40 pm #12303
    erickench
    Participant

    Use a larger wire gauge.

    2011/07/14 at 3:06 pm #12316
    admin
    Keymaster

    as same problem with me when we installed the plc to the system,

    we used the small battery as the back up power of the plc,

    the battery nominal volt is depending the plc voltage,

    or you can used Capasitor with big uF,

    hope this will solved the problem

    2011/07/16 at 8:21 pm #12323
    admin
    Keymaster

    anant said:

    i want the ans for this question

    anant said:

    i want the ans for this question

    you need to make sure you have a complete signal cable from plc to sensor or actuator or what you are controlling.

    ensure you use 0.7 0r 0.5 or 1 sqr mm signal cable and avoid making connections on one cable.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.