Home Electrical Engineering Forum General Discussion Sequential Controller,Timers

This topic contains 0 replies, has 1 voice, and was last updated by  sonaldhake 5 months, 1 week ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #18672

    sonaldhake
    Participant

    What is Maniks Solid State Sequential Controller

    The Maniks Sequential Controller has been designed to operate the Maniks pilot valves used on dust collector Equipment.Light emitting diodes (LEDs) provide visual indication of which pilot valve is being energized as well as “Power On” indication. The number of sequenced steps is adjustable from 2 through 10.Controls are provided to adjust the length of time between valves being de-energized (Pulse Frequency / Off time) and the length of time that the valve is energized (Pulse Duration / On time). Silicon semiconductor components control all timing and logic Functions.
    Two independent methods of starting and stopping the Controller are provided. The first method will automatically stop the sequence and reset the Controller to the first valve position whenever A. C. power is removed and then reconnected.
    The second method is by a remote control contact connected to the terminals provided. When the remote contact is opened, the sequence stops. When the remote contact is reclosed, the sequence continues from the previous.
    more info about sequential controller(http://www.maniks.com/)

    Thanks,
    Sonal Dhake
    +91 – 20 – 24 321 770

Viewing 1 post (of 1 total)

You must be logged or registered in to reply to this topic.

Electrical engineering Community is proudly powered by WordPress
Entries (RSS) and Comments (RSS) and license Creative Commons License