This topic contains 4 replies, has 0 voices, and was last updated by  ikram shehzad 4 years, 11 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #10501

    Dear all,

                  can anybody explain diversity factor. what is it,s defination. please tell me briefly. i have no concept about this.

    #12166

    ikram shehzad said:

    Dear all,

                  can anybody explain diversity factor. what is it,s defination. please tell me briefly. i have no concept about this.


    Dera Mr. Ikram ;

     

    The ” Deversity Fcator – Kd ” or the ” Simultaniety Factor – Ks ” are the same, and we apply this factor to ” Panels “ not to each load.

    This factor means : if we have a panel with 10 different loads, certainly these loads don't cosume in the same time 100% of their powers, because some of them consume 80%, another 100%, other 65%, so, the percantage of the Diversity Fcator means the percentage of the loads that comsume in the same time 100% of their powers.

    By experience, we use the following percentages :

    – For ” 3 ” Loads or Outgoing : 0.90

    – For ” 5 ” Loads or Outgoing : 0.80

    – For ” 9 ” Loads or Ourgoing : 0.70

    – For ” 10 or more ” loads or Outgoing : 0.60

     

    Regards.

    #12170

    thank,s dear to rply theat question.

    #12463

    admin
    Keymaster

    if you want to know more,i have to suggest to see IEE site guide

    Tables of typical allowances for diversity (Table. 1B)

    #12483
Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged or registered in to reply to this topic.

Electrical engineering Community is proudly powered by WordPress
Entries (RSS) and Comments (RSS) and license Creative Commons License